cawte,dnes som si kupil novu klavesnicu aj s myskou ,chicony a je to bez drotove..........ale nemozem to nainstalovat,nainstalujem drivre k tomu aj baterky su tam a stale to nejde co s tym???

a zapol si ich ...mali by byt na nich take gombiky na zapnutie pre setrenie energie

gombiky su neni na nich ziadne .........ale uz ma to se*ie,sakk kokos preco to nechce isttt.........ten vysielac na signal stale blika a on by mal asi svietit........mam tam zapojenu staru klavesnicu aj mys cez ps/2 a asi to berie len tie stare,skusal som aj odpajat aj neviem co vsetko

nikto mi nepomoze???

Stlac ten gombik na vysielaci stalc gombik na klavesnici a na myske a musi to ist myska s klavesnicu mozu byt v obratenom poradi neviem to presne a ked nejde tak neviem

no ako si to nejde ani tak.na klavescnici aky gombik ,to je jedno hociaky a potom na myske,?:..to som skusal aj v opacnom poradiii ale fakt uz neviem a mam nervy......stale to len blika sec a potom prestane uplne svietit a nejde to....ale pritom stara mi ide co je do ps/2

preco to nejdeee ......do keluu.,...ja to surne potrebujem aby to uz slo

ked stlacim ten gombik spustaci na vysielacii co ide z USB portu tak mi pise takuto tabulku a neviem co s tym.,prosim poradte

Warning!Receiver Channel changed.

when you see this notice that means your receiver is in the channel setting mode.
Please follow below instruction to select your preferred channel.
Otherwise please wait 30 seconds until receiver resets automatically.
Your keyboard or mouse will stop working until completing this procedure or receiver resets.

To change channels or ID
the procedurees below are to change the ID or channel.
Change the ID can prevent other receiver to get yout key codes.
Change the channel can improve the receiver sensitivity.

Change ID.
Please press the ID button on the bottom of the keyboard or mouse for more than two seconds,
and then the ID will be changed when release the ID button.

Change channel
Please press the ID button on the bottom of the keyboard or mouse and then release it,
the channel of the keyboard or mouse will be changed.
Notice not press the ID button for more than two seconds,
because the ID will be change by this way.

NOTE: The keyboard or mouse and receiver will go back to the original setting
if the change is not completed in 30 second.

dakujem